Tajima DG by Pulse Community - DG/ML General Discussion - Corel Draw Fusion Tool - Messages https://dgcommunity.pulsemicro.com/topic2186-corel-draw-fusion-tool.aspx Tajima DG by Pulse Community - DG/ML General Discussion - Corel Draw Fusion Tool - Messages en-us http://blogs.law.harvard.edu/tech/rss Jitbit AspNetForum Tue, 08 Jun 2021 21:38:52 GMT Tue, 08 Jun 2021 21:38:52 GMT https://dgcommunity.pulsemicro.com/topic2186-corel-draw-fusion-tool.aspx Message from Tajima Software gail.reilly wrote:
I have Tajima Pulse 14 Maestro and Coral Draw 12 and for some reason or other Coral Draw 12 is not coming in right. I can not see them side by side either. I can not auto digitize either. Please tell me what I could be doing wrong



Hello gail.reilly,

Tajima DG/ML14 by Pulse is an older system that supports CorelDRAW X3, X4, X5 and X6. If you have a newer version of CorelDRAW, it will not interact correctly with DG/ML14 unfortunately.]]> Tue, 08 Jun 2021 21:38:52 GMT https://dgcommunity.pulsemicro.com/topic2186-corel-draw-fusion-tool.aspx Message from gail.reilly Sun, 06 Jun 2021 20:56:56 GMT https://dgcommunity.pulsemicro.com/topic2186-corel-draw-fusion-tool.aspx Message from Tajima Software
Could you please tell us which version of DG you are using? Is it DG16, DG15, or an earlier version? At this time, DG16 only works with Corel 2020, so it may be a compatibility issue if you have an older or newer version.

If this is a DG issue rather than Embroidery i2, we will move this thread to the appropriate DG section after your reply.]]> Fri, 04 Jun 2021 19:00:38 GMT https://dgcommunity.pulsemicro.com/topic2186-corel-draw-fusion-tool.aspx Message from CrossEyedCat Sat, 29 May 2021 21:19:39 GMT